1.5HP 900W Swimming Pool Pump Motor In/Above Ground 6500GPH 51FT Hmax w/Strainer

Description: DESCRIPTION： 🐳This swimming pool pump is made with heavy-duty, corrosion-proof construction. The stainless steel motor shaft is constructed with a reinforced thermoplastic body for longer life and durability. Advanced engineering provides high efficiency and minimal noise. This wonderful swimming pool pump will surely keep your above ground and inground pools clean.Please connect only to a grounding type receptacle protected by a ground-fault circuit-interrupter (GFCI). To reduce the risk of electric shock, install at least 10 feet from the inside walls of a pool. Do not use an extension cord. This pump is for use with permanently installed pools only-Do not use with storable pools. About the item: 🐳 POWERFUL PUMP -- This pool pump is quiped With IP55 1100W electric motor,high efficiency Impeller maximize flow and reduce noise,offers dependable performance, energy efficiency and quiet operation.Copper wire motor provides not only a more efficient, stable and safe operation, but also has a longer service life compared to ordinary motors. The powerful flow can achieve 6500 GPH and the maximum head lift can reach 51 ft.🐳 STURDY CONSTRUCTION -- This 1.5HP Pool Pump is featured with commercial-grade reinforced thermoplastic shell and stainless steel motor housing,provides you with high-performance suction power and optimal flow.Suitable for swimming pools, hot tubs, thermal springs, spas and irrigation system .Ideal for all-weather performance and quiet operation.The 100% drip proof, heat-resistant seal offers a long motor life. Specification:Type:Swimming Pool PumpMaterial:ABSColor:BlackRated voltage: 110vRated frequency: 50HzHorse Power:1.5HPFlow rate: 6500 GPHLift: 51ft/15.54mWaterproof:IP55 IP RatingSuitable For:In Ground Pools&Above Ground 1.Warm Tips:When pumping water: The pump head is filled with water; the pump head transparent cover is tightened; the water pumpinlet and outlet joints are installed, and the raw material belts are tightened when the pipes are installed to prevent air leakage at the joints of the pipes.Before pumping：The pump head should be filled with water.Inlet and outlet joints wrapped around the raw material tape, beware of leaks.Tightening when installing the inlet and outlet, beware of leaks.The pump head transparent cover is tightened to prevent air leakage and water seepage 2,Pump motor tripCauses:1,The water pump motor enters water or pump operating environment is excessively humid, and causing the motor to short-circuit and burn.2,The pump prevents the inlet from entering the water and burns the motor 3,There is Water in The PumpCauses:Our company carries out a full inspection (pumping) of the water pump, and it might result in some package still leave some water in it, It is normal. 4,The Pump stop working suddenlyCauses:Our company's products are equipped with temperature protection device, when the motor temperature is too high, the temperature protection device will start, It will stop pump working, if the motor is shut down in the normal operation process , generally there is foreign matter inhalation in the pump, resulting in the impeller stuck, motor temperature rise , pump stop working. Solution:Clean up the waste inside the filter On Sep 1, 2024 at 21:59:24 PDT, seller added the following information:

Price: 107.99 USD

Location: Ontario, California

End Time: 2024-11-02T04:30:19.000Z

Shipping Cost: 0 USD