210MM Manual Sheet Metal Iron Aluminum Copper Plate Bending Machine

Description: name: 210 bending machine Bending angle: 0-180 degrees (below 45 degrees to complete in two) Bending width (maximum): 180mm on both sides, 210mm on one side Bending length: (minimum) 50x14mm (minimum size of indicating plate) Bending thickness: 0.1-2mm (2mm or more depends on the material used and the width of the board) Bending bar parameters: round bar 3-8mm (10mm) (stainless steel should be reduced by one level) Instructions Installation, this machine has two split handles. Generally, there is no need to fix it. The two handles can be used directly for bending. If possible, use the four mounting holes on the machine to fix it. This will save effort and use more smoothly. To adjust the plate thickness, insert one piece of the plate (or something of equal thickness) to be bent under the pressure plate first. The plate should not be placed too far in the front, and the other piece should be inserted about 1 cm in front, and then the upper pressure screw is lightly tightened by hand. Next, turn the flap up to form a 90-degree angle with the pressure plate, insert the other one to the end, and then tighten the front and rear adjustment screws until the pressure plate is in contact with the inserted plate, and the thickness adjustment is completed. This is because the spacing can be completely pressed in place with the adjustment method. Fold the plate, insert the lower material into the bending machine, adjust the position to be bent, and tighten the upper pressure screw. At this time, the tightness of the upper pressure screw will affect the straightness of the bending angle. Generally, tools are used Just screw it to a little tight. The front and rear adjustment screws are adjusted in the front and generally do not need to be moved. Turn the flap to start bending and bend the required angle. At this time, the pressure plate is firmed by the deformation force of the bending angle, and the upper pressure screw is loosened firmly. The front and rear adjustment screws are not needed. , Take out the bent workpiece. There are two biggest relationships between the radian of the angle and the ideal angle to be folded. One is the strength of the fuselage, and the strength of the fuselage has a certain relationship with the bent sheet, thickness and width. The other is the density of the spacing adjustment. The corners that will be folded together will be straight and beautiful.

Price: 145.59 USD

Location: China

End Time: 2024-08-31T03:44:24.000Z

Shipping Cost: 86 USD