Lytro Light Field Camera - 16 GB - Red Hot colour - NEW

Description: Lytro Light Field Camera - 16 GB - Red Hot colour - NEW - SEALED. - - - - Helpful Hints: To update the firmware, first need to install 'Lytro Desktop' to your PC then connect camera via USB. Open Lytro Desktop -> click 'info' on the left pane you see the current version of the camera's firmware. 'Update Firmware' it will update camera's firmware to 1.2.2.Important first steps for your Lytro camera Due to the nature of the Lytro camera’s battery and charging circuits, your Lytro camera has been shipped with a fully discharged battery, in order for your camera to be able to be charged, and ultimately used you will need to follow these simple steps below. This is a once-only requirement and you will not need to do this again after you start using your camera. Steps: ==> Please follow these instructions exactly; the order and timing are very important! ⇐1. You must connect the camera to USB power first, and leave it connected, before proceeding.2. You must be directly connected to your computer or to a wall AC adapter; do NOT use a USB hub.3. Hold down the Power button, near the USB flap on the underside of the camera (NOT the Shutter button) for a full 45 seconds, using a timepiece to verify duration:4. If still no results, perform an "extended hard reset" by holding down the Power button for a full 90 seconds, again using a timepiece to verify duration.5. You should then charge your camera fully for the first time (overnight or 6 hours). Please note, memory capacity is inclusive of pre-loaded apps and data, and determined by the manufacturer. The available memory will be less than what is listed above

Price: 599 AUD

Location: Enfield, SA

End Time: 2023-09-15T06:13:32.000Z

Shipping Cost: 63.77 AUD